![]() ![]() pio/build/mega2560/firmware.elfĪdvanced Memory Usage is available via "PlatformIO Home > Project Inspect" #warning "Your Configuration provides no method to acquire user feedback!"Ĭhecking size. Marlin/src/inc/Warnings.cpp:63:4: warning: #warning "Your Configuration provides no method to acquire user feedback!" LDF Modes: Finder ~ chain, Compatibility ~ softĬompiling. HARDWARE: ATMEGA2560 16MHz, 8KB RAM, 248KB FlashĭEBUG: Current (avr-stub) On-board (avr-stub, simavr) PLATFORM: Atmel AVR (3.4.0) > Arduino Mega or Mega 2560 ATmega2560 (Mega 2560) Verbose mode can be enabled via `-v, -verbose` option Processing mega2560 (board: megaatmega2560 platform: framework: arduino) Then I upload it to the board and get this.Įxecuting task in folder Marlin-2.1.1: platformio run -target upload ![]() I built it with Visual Studio code and platform IO - no errors, a couple of warnings about feedback. I downloaded Marlin 2.1.1 and edited the file Configuration_adv.h I'm sorry, I think I've done something wrong. Then I get a little lost as the docs branch out with standard, inline, dynamic inline and trapiziod modes and power.Ĭan anyone decode this voodoo for a layman who wishes to learn, perhaps with a single set of clear instructions regarding what I need to connect where and what needs to be in the config to make it work?Īny help and advice is greatly received - many thanks in advance. I need to enable LASER_FEATURE in Configuration_adv.h - DONE I'm just a little out of my depth with the config of marlin. When I connected the red and white to the 12v input cable and then connected to yellow to a 5v pin the laser comes on so I've proven the laser worked (one of my main concerns) If I connect the red and white wires to the Fan output (D9) I can vary the speed that the fan on the laser is running with M106 s(1-255) but there is no laser light. Input interface H2.54-3Pin (+,-, PWM/TTL) The laser is a 12v 10W (80w according to the listing [ with an The controller is an Arduino mega2560 with a RAMPS 1.4 sat on top I've built a MPCNC and I planning on mounting a laser module so I can cut and engrave. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |